Canon imageRUNNER 2535 E110 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E110 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535 E110 0002 Error Code
The speed lock signal indicates a deviation 10 times in sequence at intervals of 100 msec after the signal has indicated a locked state.
* The same condition is detected after the error retry is performed.
1.Check the cable.
2.Replace the Laser Scanner Unit.
3.Replace the DC Controller PCB (PCB4).
Remember that, not every error is simply the same. What corrects the complication one time might not resolve it the next time. While the help and advice in this article is obtained from the service manual and usually should get your piece of equipment up and running, on occasion other things can be in play.
If you’re looking over this page and have knowledge about this fault and wish to make a contribution make sure you leave a comment below. Or, if you have read this article and have additional questions then ask. If I have information about the problem then I will reply.