Canon imageRUNNER 2535 E110 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E110 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535 E110 0003 Error Code
The scanner motor (M21) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed.
* The same condition is detected after the error retry is performed.
1.Check the cable.
2.Replace the Laser Scanner Unit.
3.Replace the DC Controller PCB (PCB4).
Remember that, not every error is simply identical. What fixes the difficulty one time might not eliminate it the next occasion. While the ideas in this written piece is taken from the service manual and most often should get your product operational, sometimes additional circumstances may be in play.
If you’re looking over this page and have information about this problem and would wish to contribute please leave a comment beneath. Or, if you have read this article and have more questions then ask. If I have information about the issue then I will respond.