Canon imageRUNNER 2535 E248 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535 E248 0000 Error Code
1.An error has occurred at power-on.
2.An error has occurred during write operation.
3.An error has occurred during read operation following write operation.
1.Disconnect and then connect the flexible cable(Relay PCB (PCB2)-Main Controller PCB (PCB1) 50pin).
2.Disconnect and then connect the flexible cable(CCD unit- Relay PCB (PCB2)).
3.Disconnect and then connect the power supply harness connector.
4.Replace the flexible cable.
5.Replace the CCD Unit.
6.Replace the Relay PCB (PCB2).
7.Replace the Power Supply PCB (PCB3).
8.Replace the Main Controller PCB (PCB1).
Remember that, not every error is precisely alike. What fixes the malfunction one occasion might not exactly eliminate it the next occasion. While the help and advice in this written piece hails from the service manual and oftentimes ought to get your device operating, sometimes other reasons might be in play.
If you’re looking over this document and have knowledge of this malfunction and would wish to contribute make sure you leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have knowledge about the problem then I will answer back.