Canon imageRUNNER 2535 E575 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E575 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535 E575 0001 Error Code
The gripper unit does not leave the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 3.8 seconds.
1.Replace the Gripper Unit HP Sensor (S7).
2.Replace the Gripper Unit Move Motor (M2).
3.Replace the Finisher Controller PCB (PCB1).
Remember that, not every error is entirely the same. What fixes the issue one occasion may not remedy it the next occasion. While the ideas in this piece of content is inspired by the service manual and in most cases should get your product operating, at times other factors may be in play.
If you’re looking over this document and have experience with this malfunction and desire to share make sure you leave a comment below. Or, if you have read this article and have more questions then ask. If I have experience with the problem then I will respond.