Canon imageRUNNER 2535 E804 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E804 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535 E804 0000 Error Code
When lock signal is detected for 5 sec while the Power Supply Cooloing Fan (FAN6) is stopped.
* The same condition is detected after the error retry is performed.
1.Disconnect and then connect the connector (J205) on the DC Controller PCB (PCB4).
2.Replace the Power Supply Cooloing Fan (FAN6).
3.Replace the DC Controller PCB (PCB4).
Remember that, not every error is completely identical. What treats the difficulty one time might not exactly solve it the next occasion. While the details in this page is obtained from the service manual and in most cases should get your unit ready to go, occasionally additional variables can be in play.
If you’re looking over this blog post and have exposure to this fault and would like to share please make sure to leave a comment below. Or, if you have read this article and have more questions then ask. If I have knowledge about the problem then I will reply.