Canon imageRUNNER 2535 E805 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535 E805 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535 E805 0001 Error Code
1.When lock signal failed to be detected for 5 sec while the Exhaust Fan (Rear) (FAN3) is driven.
2.When lock signal failed to be detected for 5 sec while the Finisher Fan 1 (M8) is driven.
3.When lock signal failed to be detected for 5 sec while the Finisher Fan 2 (M9) is driven.
* The same condition is detected after the error retry is performed.
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Rear) (FAN3).
3.Replace the Finisher Fan 1 (M8).
4.Replace the Finisher Fan 2 (M9).
5.Replace the DC Controller PCB (PCB4).
Remember that, not every error is completely identical. What remedies the complication one occasion might not exactly take care of it the next time. While the content in this write-up hails from the service manual and generally ought to get your machine functioning, in some cases additional circumstances could possibly be in play.
If you’re looking over this blog post and have expertise in this malfunction and would wish to make a contribution please be sure to leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have knowledge about the trouble then I will answer.