Canon imageRUNNER 2535I E000 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E000 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535I E000 0001 Error Code
The temperature detected by the main thermistor does not rise to the specified value during startup control.
1.Go through the following to clear the error: CLEAR > ENGIN > ERRCLR; and then turn OFF and then ON the power.
2.Check connection of the Connectors (Thermistor Connector and AC Connector).
3.Replace the Fixing Main Thermistor (Film Unit).
4.Replace the Fixing Assembly.
5.Replace the DC Controller PCB (PCB4).
Remember that, not every error is completely identical. What corrects the issue one occasion may possibly not remedy it the next occasion. While the content in this write-up is taken from the service manual and typically ought to get your equipment functioning, at times additional factors may be in play.
If you’re looking over this blog post and have expertise in this error message and want to make a contribution be sure to leave a comment down below. Or, if you have read this article and have additional questions then ask. If I have experience with the problem then I will answer.