Canon imageRUNNER 2535I E002 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E002 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535I E002 0000 Error Code
1.The reading of the main thermistor is less than 115 deg C continuously for 400 msec 1.3 sec after it has indicated 100 deg C.
2.The reading of the main thermistor is less than 150 deg C continuously for 400 msec 1.3 sec after it has indicated 140 deg C.
1.Go through the following to clear the error: CLEAR > ENGIN > ERRCLR; and then turn OFF and then ON the power.
2.Check connection of the Connectors (Thermistor Connector and AC Connector).
3.Replace the Fixing Main Thermistor (Film Unit).
4.Replace the Fixing Assembly.
5.Replace the DC Controller PCB (PCB4).
Remember that, not every error is completely alike. What corrects the condition one occasion might not remedy it the next occasion. While the information in this blog post is obtained from the service manual and most likely should get your device up and running, sometimes other things could possibly be in play.
If you’re looking over this blog post and have experience with this problem and desire to make a contribution please make sure to leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have knowledge about the situation then I will answer back.