Canon imageRUNNER 2535I E003 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E003 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535I E003 0000 Error Code
The reading of the main thermistor is less than 140 deg C continuously for 400 msec or more.
1.Go through the following to clear the error: CLEAR > ENGIN > ERRCLR; and then turn OFF and then ON the power.
2.Check connection of the Connectors (Thermistor Connector and AC Connector).
3.Replace the Fixing Main Thermistor (Film Unit).
4.Replace the Fixing Assembly.
5.Replace the DC Controller PCB (PCB4).
Remember that, not every error is absolutely the same. What treats the situation one time might not remedy it the next occasion. While the ideas in this piece of content is obtained from the service manual and in most cases should get your equipment up and running, on occasion other reasons may be in play.
If you’re looking over this blog post and have experience with this malfunction and wish to contribute make sure you leave a comment beneath. Or, if you have read this article and have further questions then ask. If I have knowledge about the problem then I will answer.