Canon imageRUNNER 2535I E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2535I E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2535I E531 8002 Error Code
The stapler does not return to the staple home position when the Stapler Motor (M10) has been driven for 0.5 sec.
1.Check the wiring between the Finisher Controller PCB and Stapler.
2.Replace the Stapler.
3.Replace the Finisher Controller PCB (PCB1).
Realize, not every error is precisely the same. What treats the trouble one time may not fix it the next time. While the advice in this blog post is taken from the service manual and oftentimes ought to get your device operating, at times additional circumstances might be in play.
If you’re looking at this write-up and have expertise in this fault and desire to contribute please leave a comment below. Or, if you have read this article and have more questions then ask. If I have information about the issue then I will answer back.