Canon imageRUNNER 2545 E110 0003 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E110 0003 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2545 E110 0003 Error Code
The scanner motor (M21) speed lock signal does not indicate a locked state for 6.5 sec. after a switchover is made from low to normal speed or for 8 sec. after a switchover is made from normal to low speed.
* The same condition is detected after the error retry is performed.
1.Check the cable.
2.Replace the Laser Scanner Unit.
3.Replace the DC Controller PCB (PCB4).
Please remember, not every error is totally identical. What corrects the problem one occasion may not remedy it the next occasion. While the info in this article originates from the service manual and in most cases should get your device operational, now and again other variables may be in play.
If you’re looking at this piece of content and have information about this error and would wish to contribute please make sure to leave a comment underneath. Or, if you have read this article and have further questions then ask. If I have experience with the problem then I will respond.