Canon imageRUNNER 2545 E531 8002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E531 8002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2545 E531 8002 Error Code
The stapler does not return to the staple home position when the Stapler Motor (M10) has been driven for 0.5 sec.
1.Check the wiring between the Finisher Controller PCB and Stapler.
2.Replace the Stapler.
3.Replace the Finisher Controller PCB (PCB1).
Please remember, not every error is exactly the same. What fixes the difficulty one occasion might not exactly get rid of it the next occasion. While the data in this document originates from the service manual and most likely should get your device operating, at times other things can be in play.
If you’re looking at this page and have information about this error message and would wish to make a contribution please make sure to leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have information about the problem then I will reply.