Canon imageRUNNER 2545 E805 0001 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E805 0001 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2545 E805 0001 Error Code
1.When lock signal failed to be detected for 5 sec while the Exhaust Fan (Rear) (FAN3) is driven.
2.When lock signal failed to be detected for 5 sec while the Finisher Fan 1 (M8) is driven.
3.When lock signal failed to be detected for 5 sec while the Finisher Fan 2 (M9) is driven.
* The same condition is detected after the error retry is performed.
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Rear) (FAN3).
3.Replace the Finisher Fan 1 (M8).
4.Replace the Finisher Fan 2 (M9).
5.Replace the DC Controller PCB (PCB4).
Please remember, not every error is absolutely the same. What corrects the malfunction one time might not exactly resolve it the next occasion. While the data in this text hails from the service manual and oftentimes ought to get your piece of equipment up and running, from time to time other things could possibly be in play.
If you’re looking at this document and have experience with this error and would wish to make a contribution make sure you leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have information about the trouble then I will reply.