Canon imageRUNNER 2545 E805 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545 E805 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2545 E805 0002 Error Code
When lock signal is detected for 5 sec while the Exhaust Fan (Front) (FAN4) is stopped
* The same condition is detected after the error retry is performed.
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Front) (FAN4).
3.Replace the DC Controller PCB (PCB4).
Please remember, not every error is absolutely the same. What corrects the issue one time might not exactly fix it the next time. While the content in this written piece hails from the service manual and oftentimes ought to get your equipment working, now and again other reasons can be in play.
If you’re looking at this blog post and have knowledge of this fault and would like to make a contribution please be sure to leave a comment underneath. Or, if you have read this article and have additional questions then ask. If I have exposure to the issue then I will respond.