Canon imageRUNNER 2545I E248 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E248 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2545I E248 0000 Error Code
1.An error has occurred at power-on.
2.An error has occurred during write operation.
3.An error has occurred during read operation following write operation.
1.Disconnect and then connect the flexible cable(Relay PCB (PCB2)-Main Controller PCB (PCB1) 50pin).
2.Disconnect and then connect the flexible cable(CCD unit- Relay PCB (PCB2)).
3.Disconnect and then connect the power supply harness connector.
4.Replace the flexible cable.
5.Replace the CCD Unit.
6.Replace the Relay PCB (PCB2).
7.Replace the Power Supply PCB (PCB3).
8.Replace the Main Controller PCB (PCB1).
Note, not every error is precisely the same. What remedies the malfunction one occasion may not solve it the next occasion. While the content in this page is obtained from the service manual and most likely should get your product up and running, on occasion other things might be in play.
If you’re looking at this article and have exposure to this fault and desire to make a contribution please leave a comment down below. Or, if you have read this article and have further questions then ask. If I have exposure to the trouble then I will respond.