Canon imageRUNNER 2545I E575 0002 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E575 0002 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2545I E575 0002 Error Code
The gripper unit does not return to the gripper unit home position when the Gripper Unit Move Motor (M2) has been driven for 0.1 seconds.
1.Replace the Gripper Unit HP Sensor (S7).
2.Replace the Gripper Unit Move Motor (M2).
3.Replace the Finisher Controller PCB (PCB1).
Note, not every error is entirely the same. What fixes the complication one time may not take care of it the next occasion. While the content in this short article is taken from the service manual and typically ought to get your equipment up and running, from time to time other things can be in play.
If you are reading this write-up and have exposure to this problem and would like to make a contribution please make sure to leave a comment down below. Or, if you have read this article and have further questions then ask. If I have experience with the problem then I will answer back.