Canon imageRUNNER 2545I E805 0000 Error Code Instructions
Below you will find the service manual information for the Canon imageRUNNER 2545I E805 0000 Error Code along with additional details to explain what can cause the problem and followed by solutions that might help you fix it. If I have additional information from past experiences I will try to add it.
Service Manual Instructions for the Canon imageRUNNER 2545I E805 0000 Error Code
When lock signal is detected for 5 sec while the Exhaust Fan (Rear) (FAN3) is stopped.|* The same condition is detected after the error retry is performed.
1.Disconnect and then connect the connector (J206) on the DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Rear) (FAN3).
3.Replace the DC Controller PCB (PCB4).
Note, not every error is completely identical. What corrects the problem one time might not resolve it the next time. While the content in this piece of content hails from the service manual and most often ought to get your unit operating, occasionally additional variables could possibly be in play.
If you are reading this short article and have information about this fault and would like to make a contribution you should leave a comment down the page. Or, if you have read this article and have more questions then ask. If I have experience with the issue then I will answer back.